Dear all,
I am trying to perform egger test on my meta analysis of studies on the prevalence of disease A in people drinking alcohol. A sample is shown below (I do not have 2x2 table data for all the studies)
OR UCI 95% LCI 95%
0.84 0.74 0.93
0.83 0.75 0.92
1.89 1.08 3.32
1.38 0.77 2.48
On entering meta bias egger it says - You must declare your meta-analysis data using either meta set or meta esize.
I have difficulty performing this step. The help guide says:
If you are working with effect sizes in the original metric, such as odds ratios or hazard ratios, with meta set, you should specify the effect sizes and CIs in a normalizing metric, such as the log metric.
However I am not sure how to create the log metric.
Any help would be appreciated!
Related Posts with Help creating log metric for pooled odds ratio
Problem - Use 2 datasets in one do file (single run)Hi all ! I need help on stata I am trying to create one do file in Stata (mandatory) using 2 diff…
How to use estat concordance in a validation sample Hi, I am trying to internally validate the Cox proportional hazard model. I have split data (70% on…
running parmest on STATA 15Hi I was wondering if anyone could help me out a bit on the parmest command. I am using STATA 15 an…
Three-dimensional surface plots of marginal predictions using PythonDear all, I just had access to the Stata 16.0 version and I am really excited because of it. It's ju…
Model for Panel Data with time-variant DV and time-invariant IVsHello, My panel data is short (N>T) and I would like to regress 4 time invariant IV on 1 time va…
Subscribe to:
Post Comments (Atom)
0 Response to Help creating log metric for pooled odds ratio
Post a Comment